SPA CARE
  SPA Water Guide
  SPA Water Problems
  Water Terminology
  SPA Troubleshooting
  SPA Manuals
  SPA Parts
 SPA SERVICES
  SPA Opening
  SPA Closing
  Emergency Service
 
 POOL CARE
  Basic Pool Maintenance
  Filter Maintenance
  POOL Water Guide
  POOL Water Problems
  Water Terminology

  POOL Parts

 POOL SERVICES
  Inground Opening
  Aboveground Opening
  Inground Closing
  Aboveground Closing
  Sand Change Service
  Specialty Services
  Liner Replacement
 
 
 
 
  COMMERCIAL
  MSDS Sheets
  Chemistry Log Book
 
 

 

Filter Cleaning or Backwashing
You will have one of 3 types of filters: Sand, Cartridge, and Diatomaceous Earth (DE) Each will have to be cleaned on a regular basis depending on how dirty the filter becomes over time. The pool filter manufacturer has put a pressure gauge on the filters to indicate the current pressure. The trick is to get the "clean" or starting pressure initially, and when the pressure increase you would then clean or backwash the filter. Typically 10 psi difference is a good indicator it is time to clean or back wash your filter. You should consult your owners manual for proper instructions.

Sand Filter
Backwash Once per week

Cartridge
Wash every season

Diatomaceous Earth (DE)
Bump once per month

Sand Filter
Sand filters have a dial head on the top of the filter. Always switch off the pump before moving the valve. Make sure your backwash hose is unrolled completely or you will burst it. Move the valve handle from the Filter to the Backwash Position with some it is a push/pull operation & some a rotate operation. Restart the pump & let the water flow in reverse through the filter until the water at the end of the backwash hose, or the site glass,  is clear. This is about 3 to 5 minutes. Switch off the pump & move the valve to the RINSE position for 30 seconds to clear the filter & then switch off the pump & move the valve to the FILTER position. Switch on the pump & allow it to operate as normal.
Cartridge Filter
A cartridge filter is a filter that collects debris in it's pleats. You will have up to 4 filters in the filter's tank and each of those filters will have to be removed and hosed of periodically. This is called a "Quick Clean" It is recommended at the end of the season that you do a "Deep Clean". You remove the  cartridges and soak them a Filter Cleaning Solution such as Filter Free, for 24 hours and then rinse them off. This "Deep Clean" loosens the set in oils and debris that couldn't be removed with a "Quick Clean". At Oasis we offer a "Deep Clean" cartridge cleaning service and you can contact us for info.
 
Diatomaceous Earth (DE)
These filters have a set of pads inside which must be coated with the DE. The DE is the filter & it removes the dirt from the water passing through. When the dirt builds up to a point that it reduces the flow of water, the DE & its dirt must be removed. Some filters have a valve which allows you to reverse the flow through the filter to remove the DE & dirt. This works on some but not all.
In most cases you will need to remove the lid of the filter tank & take out the pads & give them a good hose down. In many cases you can use the reverse flush method normally & then each six months or so remove the pads for a good clean. After you replace the pads & refit the lid, you will need to start the pump & add more DE through the skimmer box.
 

Contact Oasis for any help on Filter Maintenance>>>

 

 

 

 

 

 
Home | Contact Us  | Customer CarePools | Spas  | Saunas | BBQ Islands | Gazebos |  New and Unique | Commercial Services